Holybro PixHawk PM06 V2-14S Power Module (15019)


  • $21.00

Holybro PixHawk PM06 V2-14S Power Module (15019)


    This PM06 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated power distribution for 4 ESCs. It comes with pre-soldered wires, capacitor, and XT60 connector.


    • Input voltage (10S version): 2S-10S
    • Input voltage (14S version): 2S-14S
    • PCB Cont. Current Rating: 70A
    • PCB Burst Current Rating: 120A (<60 Sec)
    • Output: DC 5.2V & 3A Max 
    • Ouput Max Power : 18W
    • Voltage Divider: 18.182
    • Amperes per Volt: 36.364 

    Please Note: 

    • The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference.
    • This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital PM like PM02D). 

    Mechanical Specification:

    • Dimensions: 35x35x5mm
    • Mounting hole: 30.5mm*30.5mm
    • Weight: 24g

    Pin Map:

    Setup guide for PX4 & Ardupilot can be found in the Holybro Doc here.

    Package Includes

    • 1x  PM06 board
    • 1x  80mm XT60 connector wire (installed)
    • 1x  Electrolytic capacito: 220uF 63V(installed)
    • 1x  JST GH 6pin cable
    • 1x  JST SH 6pin cable

    We Also Recommend